Spread the Lovely Idea :)
Step 4. After gluing all pieces the next step is to pour in the resin, but you have to make sure your table is all set. One of the things to look out for are holes on the surface your table. Here, the holes are covered from underneath so that the blue tape won’t show in the final design. If your table has plenty of holes in it, like a mesh, you might want to cut an MDF as cover for the entire table. Don’t forget to tape the sides of your table, too, as shown in the previous picture. This will protect your table from getting sticky with duct tape which you will be using in the next step.
Click [6] below the advertisement for step 5.
Comments are closed.